HPE Community
BladeSystem - General
1752815 Members
6093 Online
108789 Solutions
New Discussion

2 Network interface to the same interconnect bay

 
MauricioLopez
Occasional Contributor

‎03-14-2011 02:10 PM

‎03-14-2011 02:10 PM

2 Network interface to the same interconnect bay

Hi, guys.

 

c7000 enclosure

bl460c server with 2 embeded ethernet ports + HBA mezzanine + Ethernet mezzanine.

Ethernet Interconnects on Bay 1 and Bay 5 only.

Fiber Interconnect on bays 3 &4

 

Is it posible to map bl460c eth1 & eth2 to interconect on Bay 1? or do I really need an Ethernet Interconect on Bay2?

 

Best Regards

0 Kudos
Reply
1 REPLY 1
chuckk281
Trusted Contributor

‎03-15-2011 02:06 PM

‎03-15-2011 02:06 PM

Re: 2 Network interface to the same interconnect bay

The port mapping of the ports is defined for each of the blades for the 2 C-Class enclosures. In the c7000 enclosures port1 is mapped to Bay1 and Port2 is mapped to Bay2.

 

See this document on page 17 there are the port mappings:

http://h20000.www2.hp.com/bc/docs/support/SupportManual/c00816246/c00816246.pdf

 

0 Kudos
Reply
The opinions expressed above are the personal opinions of the authors, not of Hewlett Packard Enterprise. By using this site, you accept the Terms of Use and Rules of Participation.