- Community Home
- >
- Servers and Operating Systems
- >
- HPE BladeSystem
- >
- BladeSystem - General
- >
- BL25p G2 + NC320m w/ 1 port disabled
Categories
Company
Local Language
Forums
Discussions
Forums
- Data Protection and Retention
- Entry Storage Systems
- Legacy
- Midrange and Enterprise Storage
- Storage Networking
- HPE Nimble Storage
Discussions
Discussions
Discussions
Forums
Discussions
Discussion Boards
Discussion Boards
Discussion Boards
Discussion Boards
- BladeSystem Infrastructure and Application Solutions
- Appliance Servers
- Alpha Servers
- BackOffice Products
- Internet Products
- HPE 9000 and HPE e3000 Servers
- Networking
- Netservers
- Secure OS Software for Linux
- Server Management (Insight Manager 7)
- Windows Server 2003
- Operating System - Tru64 Unix
- ProLiant Deployment and Provisioning
- Linux-Based Community / Regional
- Microsoft System Center Integration
Discussion Boards
Discussion Boards
Discussion Boards
Discussion Boards
Discussion Boards
Discussion Boards
Discussion Boards
Discussion Boards
Discussion Boards
Discussion Boards
Discussion Boards
Discussion Boards
Discussion Boards
Discussion Boards
Discussion Boards
Discussion Boards
Discussion Boards
Discussion Boards
Discussion Boards
Community
Resources
Forums
Blogs
- Subscribe to RSS Feed
- Mark Topic as New
- Mark Topic as Read
- Float this Topic for Current User
- Bookmark
- Subscribe
- Printer Friendly Page
- Mark as New
- Bookmark
- Subscribe
- Mute
- Subscribe to RSS Feed
- Permalink
- Report Inappropriate Content
04-02-2012 08:17 AM
04-02-2012 08:17 AM
BL25p G2 + NC320m w/ 1 port disabled
We are using a BL25p G2 with a NC320m. 1 of the ports is listed in RBSU (and iLO) as: MAC address for NIC4: DISABLED
Can anyone tell me how to get this port enabled?
Server is:
BL25p G2 BIOS: A11 (4/5/2007) OS: HP Branded Windows Server 2003 R2 SP2
NIC is:
HP NC320m Drv ver:14.2.0.5 (B57XP32.sys) Boot code 3.58.0
HP NCU: 10.45.01
I have tried SetLACState, DevCon, and WMIC. With each tool I can enable the NIC but only under Windows. I can find the NIC in windows and assign it a driver. NCU will not see the 2nd port. I have cleared the NVRAM, Restored default system settings, erased user defaults and reset the configuration using system maint switch.
Any help or hints to a solution would be much appreciated.
Rob
- Mark as New
- Bookmark
- Subscribe
- Mute
- Subscribe to RSS Feed
- Permalink
- Report Inappropriate Content
08-08-2012 08:44 AM
08-08-2012 08:44 AM
Re: BL25p G2 + NC320m w/ 1 port disabled
Rob,
This reply is proabably a bit too late. Have you checked that the switch that links to has the port enabled at the switch side? Might be that the downlink is disabled so the blade wont enable it?
Thanks