BL680cG7 & FlexFabric Network module port mapping detail

[chuckk281]

Hai was looking for some BL680c G7 info:

***************************

Hi Team,

I am looking for the BL680cG7 & FlexFabric module port mapping detail documentation.

Much appreciated any help from you.

*****************************

Monty had the info:

*************************

The BL680c G7 quickspec contains the following port mapping information:

• Mezzanine Support:
  • Seven (7) mezzanine expansion slots as follows:
    • Four (4) Type II (25 watts) x8 PCIe Gen2, mezzanine slots 2, 3, 4, 7 supporting QDR IB, 4Gb and 8Gb FC, 10Gb FlexFabric, 10Gb Flex10, 10GbE, 1GbE, I/O accelerator cards, and the P700m.
      • Mezzanine slots' 2 and 7 ports are routed to interconnect bays 5,6,7,8 (c7000) and 3,4,3,4 (c3000)
      • Mezzanine slots' 3 and 4 ports are routed to interconnect bays 7,8,5,6 (c7000) and 3,4,3,4 (c3000)
    • Two (2) Type I (15 watts) x4 PCIe Gen2, mezzanine slots 1 and 5 supporting 4Gb and 8Gb FC,10Gb FlexFabric, 10Gb Flex10, 10GbE , 1GbE, and the I/O accelerator cards
      • Mezzanine slots' 1 and 5 ports are routed to interconnect bays 3, 4, 3, 4 (c7000) and 2,2,2,2 (c3000)
    • NOTE: HP recommends 10Gb adapters be installed in a x8 PCIe slot for optimal performance.
    • One (1) Type I (15 watts) x8 PCI Gen 2 dual-port Ethernet-specific slot (mezzanine slot 6); see above "Network Controller" section for more information
      • Mezzanine slot's 6 ports are routed to interconnect bays 1, 2 (c7000) and 1, 1 (c3000)
    • NOTE: Type II slots accept both Type I or Type II cards. Type I slots accepted Type I cards only.

***************************

Good info. Any other questions?