- Community Home
- >
- Servers and Operating Systems
- >
- HPE BladeSystem
- >
- BladeSystem - General
- >
- BL860C i2 Network Communication Failure
Categories
Company
Local Language
Forums
Discussions
Forums
- Data Protection and Retention
- Entry Storage Systems
- Legacy
- Midrange and Enterprise Storage
- Storage Networking
- HPE Nimble Storage
Discussions
Discussions
Discussions
Forums
Discussions
Discussion Boards
Discussion Boards
Discussion Boards
Discussion Boards
- BladeSystem Infrastructure and Application Solutions
- Appliance Servers
- Alpha Servers
- BackOffice Products
- Internet Products
- HPE 9000 and HPE e3000 Servers
- Networking
- Netservers
- Secure OS Software for Linux
- Server Management (Insight Manager 7)
- Windows Server 2003
- Operating System - Tru64 Unix
- ProLiant Deployment and Provisioning
- Linux-Based Community / Regional
- Microsoft System Center Integration
Discussion Boards
Discussion Boards
Discussion Boards
Discussion Boards
Discussion Boards
Discussion Boards
Discussion Boards
Discussion Boards
Discussion Boards
Discussion Boards
Discussion Boards
Discussion Boards
Discussion Boards
Discussion Boards
Discussion Boards
Discussion Boards
Discussion Boards
Discussion Boards
Discussion Boards
Community
Resources
Forums
Blogs
- Subscribe to RSS Feed
- Mark Topic as New
- Mark Topic as Read
- Float this Topic for Current User
- Bookmark
- Subscribe
- Printer Friendly Page
- Mark as New
- Bookmark
- Subscribe
- Mute
- Subscribe to RSS Feed
- Permalink
- Report Inappropriate Content
11-16-2010 12:45 PM
11-16-2010 12:45 PM
BL860C i2 Network Communication Failure
Mark had a network question for his BL860c i2 blades
*********************
Hello,
We just installed two BL860CI2 servers into a C7000 chassis with Cisco 3020 Interconnect modules. The chassis is running OA firmware version 3.11. I am able to communicate just fine with the ILO mgmt port on the two servers, but cannot get networking going with the built-in FLEX-10 NICs. From an OS perspective I can configure LAN0 just fine, but am unable to ping any hosts inside or outside the enclosure that are on the same subnet and VLAN.
The servers are both configured wit hpux 11.31 September 2010 release. The Cisco switch is running 12.2(40)SE2. Would anyone know if by chance the BL860CI2 is not compatible with the Cisco 3020, or if the version of the OS would be preventing communication?
******************************
Alexei had some help:
********************
I think, you have to upgrade Cisco IOS to v 12.2.50 and later...
See http://h41302.www4.hp.com/km/saw/view.do?docId=emr_na-c01869687&hsid=11203897
*********************
Any other comments or suggestions?