- Community Home
- >
- Servers and Operating Systems
- >
- HPE BladeSystem
- >
- BladeSystem - General
- >
- BL860c i2 stuck at Launch Boot Manager
Categories
Company
Local Language
Forums
Discussions
Forums
- Data Protection and Retention
- Entry Storage Systems
- Legacy
- Midrange and Enterprise Storage
- Storage Networking
- HPE Nimble Storage
Discussions
Discussions
Discussions
Forums
Discussions
Discussion Boards
Discussion Boards
Discussion Boards
Discussion Boards
- BladeSystem Infrastructure and Application Solutions
- Appliance Servers
- Alpha Servers
- BackOffice Products
- Internet Products
- HPE 9000 and HPE e3000 Servers
- Networking
- Netservers
- Secure OS Software for Linux
- Server Management (Insight Manager 7)
- Windows Server 2003
- Operating System - Tru64 Unix
- ProLiant Deployment and Provisioning
- Linux-Based Community / Regional
- Microsoft System Center Integration
Discussion Boards
Discussion Boards
Discussion Boards
Discussion Boards
Discussion Boards
Discussion Boards
Discussion Boards
Discussion Boards
Discussion Boards
Discussion Boards
Discussion Boards
Discussion Boards
Discussion Boards
Discussion Boards
Discussion Boards
Discussion Boards
Discussion Boards
Discussion Boards
Discussion Boards
Community
Resources
Forums
Blogs
- Subscribe to RSS Feed
- Mark Topic as New
- Mark Topic as Read
- Float this Topic for Current User
- Bookmark
- Subscribe
- Printer Friendly Page
- Mark as New
- Bookmark
- Subscribe
- Mute
- Subscribe to RSS Feed
- Permalink
- Report Inappropriate Content
10-28-2010 08:03 AM
10-28-2010 08:03 AM
BL860c i2 stuck at Launch Boot Manager
Stephen needed some help:
************************
A BL860c i2 has behaved very well until I (mis-)configured for Boot from SAN. Installation etc went well to SAN disk, but then I started playing with the EFI menus for adding boot file entries etc.
Problem is I have gotten the state of the system to hang at EFI_LAUNCH_BOOT_MANAGER.
How can I recover from here? – I have tried reset and re-power, but can’t get past this state.
**************************
Thomas had some suggestions to try:
********************
Check all of your available console ports (iLO serial console, VGA). You may have accidently disabled the active console you were using prior to the OS install.
****************
And then Stephen got the answer to his problem:
********************
For anyone else with this problem, it is resolved by:
1) Reset MP: CM> xd –r –nc
2) Recycle power: pc –cycle –nc
Thanks to Gil.
****************************
Hope that helps you if you get stuck.