- Community Home
- >
- Servers and Operating Systems
- >
- HPE BladeSystem
- >
- BladeSystem - General
- >
- Bl460C Gen9 opcode 6 error post code 450
Categories
Company
Local Language
Forums
Discussions
Forums
- Data Protection and Retention
- Entry Storage Systems
- Legacy
- Midrange and Enterprise Storage
- Storage Networking
- HPE Nimble Storage
Discussions
Discussions
Discussions
Forums
Discussions
Discussion Boards
Discussion Boards
Discussion Boards
Discussion Boards
- BladeSystem Infrastructure and Application Solutions
- Appliance Servers
- Alpha Servers
- BackOffice Products
- Internet Products
- HPE 9000 and HPE e3000 Servers
- Networking
- Netservers
- Secure OS Software for Linux
- Server Management (Insight Manager 7)
- Windows Server 2003
- Operating System - Tru64 Unix
- ProLiant Deployment and Provisioning
- Linux-Based Community / Regional
- Microsoft System Center Integration
Discussion Boards
Discussion Boards
Discussion Boards
Discussion Boards
Discussion Boards
Discussion Boards
Discussion Boards
Discussion Boards
Discussion Boards
Discussion Boards
Discussion Boards
Discussion Boards
Discussion Boards
Discussion Boards
Discussion Boards
Discussion Boards
Discussion Boards
Discussion Boards
Discussion Boards
Community
Resources
Forums
Blogs
- Subscribe to RSS Feed
- Mark Topic as New
- Mark Topic as Read
- Float this Topic for Current User
- Bookmark
- Subscribe
- Printer Friendly Page
- Mark as New
- Bookmark
- Subscribe
- Mute
- Subscribe to RSS Feed
- Permalink
- Report Inappropriate Content
01-02-2015 10:38 AM
01-02-2015 10:38 AM
Bl460C Gen9 opcode 6 error post code 450
After a reboot of two new blades bl460c gen9 I have an opcode error 6 and it stops at post code 450.
I already have tried a cold boot, a reset, reset of the blade slot. I even tried the f9, f10 and f11. they stop wordking and I recieve an opcode 6 error.
The are in an c7000 with firmware 4.30.
I included a print screen of one of the two servers.
- Mark as New
- Bookmark
- Subscribe
- Mute
- Subscribe to RSS Feed
- Permalink
- Report Inappropriate Content
01-05-2015 12:45 AM
01-05-2015 12:45 AM
Re: Bl460C Gen9 opcode 6 error post code 450
Hi,
Was the Operating system installed in Legacy Mode and then the Boot Mode changed to UEFI mode or vice versa?
Were any changes made to other settings in RBSU?
Could more information about the issue be provided?
Regards,
Vijayasarathy
Views expressed herein are my personal opinion and are not the views of HPE
- Mark as New
- Bookmark
- Subscribe
- Mute
- Subscribe to RSS Feed
- Permalink
- Report Inappropriate Content
01-05-2015 02:17 AM
01-05-2015 02:17 AM
Re: Bl460C Gen9 opcode 6 error post code 450
I think the following problem is the cause of the opcode error.
From our eva storage and our Purestorage we connect, through a glassboard, a lot of lun's . The booting time of the blade is longer the more lun's we connect.
I think there is a threshold if we connect less lun's the server boots correctly. Only the booting time is longer than if there are no lun's connected to the server.
Is there a threshold?
At this moment we are connecting 32 lun's to the blade server