- Community Home
- >
- Servers and Operating Systems
- >
- HPE BladeSystem
- >
- BladeSystem - General
- >
- Blade Installation in same quadrant question
Categories
Company
Local Language
Forums
Discussions
Forums
- Data Protection and Retention
- Entry Storage Systems
- Legacy
- Midrange and Enterprise Storage
- Storage Networking
- HPE Nimble Storage
Discussions
Discussions
Discussions
Forums
Discussions
Discussion Boards
Discussion Boards
Discussion Boards
Discussion Boards
- BladeSystem Infrastructure and Application Solutions
- Appliance Servers
- Alpha Servers
- BackOffice Products
- Internet Products
- HPE 9000 and HPE e3000 Servers
- Networking
- Netservers
- Secure OS Software for Linux
- Server Management (Insight Manager 7)
- Windows Server 2003
- Operating System - Tru64 Unix
- ProLiant Deployment and Provisioning
- Linux-Based Community / Regional
- Microsoft System Center Integration
Discussion Boards
Discussion Boards
Discussion Boards
Discussion Boards
Discussion Boards
Discussion Boards
Discussion Boards
Discussion Boards
Discussion Boards
Discussion Boards
Discussion Boards
Discussion Boards
Discussion Boards
Discussion Boards
Discussion Boards
Discussion Boards
Discussion Boards
Discussion Boards
Discussion Boards
Community
Resources
Forums
Blogs
- Subscribe to RSS Feed
- Mark Topic as New
- Mark Topic as Read
- Float this Topic for Current User
- Bookmark
- Subscribe
- Printer Friendly Page
- Mark as New
- Bookmark
- Subscribe
- Mute
- Subscribe to RSS Feed
- Permalink
- Report Inappropriate Content
04-24-2014 07:24 AM - edited 04-24-2014 07:26 AM
04-24-2014 07:24 AM - edited 04-24-2014 07:26 AM
Blade Installation in same quadrant question
A blade installation question from Ismail:
**************
One our customer would like to install 2x BL460c Gen 8 (half height) and 1 x BL660c (full height) Gen8 beside each other. He would like to install BL460x Gen8 in bay 5 & 13 and the BL660c Gen8 in bay 6. As far as I know there is no way to install them beside each other. Could you please if this setup is supported by any documents?
**************
Input from Cullen:
************
You can’t mix 2 BL460s and one BL660 in the same quadrant. The reason is one of physical support – the half-height blade in the top slot will put a strain on the midplane connectors and could fall out if the bottom blade is removed. That could damage both the server and the midplane. The only way to mix 2 half-height blades with a full-height blade in a quadrant is to have an expansion blade in the bottom slot with a support bracket attached to support the blade above.
Both the C7000 QuickSpecs and the user guide describe this.
**************
And info from Kim:
***************
Not supported
The c7000 enclosure is divided into four zones or quadrants by the vertical support metalwork. Within each zone, a removable divider is used to support half-height devices. To install a full-height blade in any zone, this divider must be removed. As a consequence, a zone can only contain either full-height server blades or half-height server blades.
****************
Comments?