Simpler Navigation for Servers and Operating Systems - Please Update Your Bookmarks
Completed: a much simpler Servers and Operating Systems section of the Community. We combined many of the older boards, so you won't have to click through so many levels to get at the information you need. Check the consolidated boards here as many sub-forums are now single boards.
If you have bookmarked forums or discussion boards in Servers and Operating Systems, we suggest you check and update them as needed.
BladeSystem Server Blades
cancel
Showing results for 
Search instead for 
Did you mean: 

C7000 mixing half and full baldes in a zone

elgamal2020
Occasional Visitor

C7000 mixing half and full baldes in a zone

Hello,

 

I have read on the quick spec guide that there is no possibility to mix full hight and half height within a quadrant zone .

 

Is there any way to overcome this limitation via any customized solution as I have reamianing two slots which I want to install two half blade while there is already another full blade installed in this zone ?

 

Thanks in advance 

Best Regards

1 REPLY
Torsten.
Acclaimed Contributor

Re: C7000 mixing half and full baldes in a zone

You cannot install a half height blade in the upper row, because there is no divider that can hold the blade in this position. Your only workaround may be to install a blade in the lower bay only.


Hope this helps!
Regards
Torsten.

__________________________________________________
There are only 10 types of people in the world -
those who understand binary, and those who don't.

__________________________________________________
No support by private messages. Please ask the forum!

If you feel this was helpful please click the KUDOS! thumb below!