BladeSystem - General
1745847 Members
4308 Online
108723 Solutions
New Discussion

E-Fuse error showing on OA for a blade server

 
1_Fred
New Member

E-Fuse error showing on OA for a blade server

One HP BL680c G7 Server in a C7000 chassis is not coming up or being recognised by the the OA. It is reporting an efuse error. We have ssh'ed into the OA and run the following command with no change: "reset bay x" and "reset server x" where x is the bay the server is loacted in.

We have also tried to reseat the server and even changed the bays with no change.

Any pointers to the cause and solution to this issue?

Kindly help...

1 REPLY 1
msh_it
Regular Advisor

Re: E-Fuse error showing on OA for a blade server

Try to power on the server with minimum config, 1CPU 1Mem, no mezz and check the output.

else you may require replacing the system board.

-------------------------------

msh_it | UAE | AbuDhabi

If you feel this was helpful please click the KUDOS! Below!