- Community Home
- >
- Servers and Operating Systems
- >
- HPE BladeSystem
- >
- BladeSystem - General
- >
- E-Fuse error showing on OA for a blade server
Categories
Company
Local Language
Forums
Discussions
Forums
- Data Protection and Retention
- Entry Storage Systems
- Legacy
- Midrange and Enterprise Storage
- Storage Networking
- HPE Nimble Storage
Discussions
Discussions
Discussions
Forums
Discussions
Discussion Boards
Discussion Boards
Discussion Boards
Discussion Boards
- BladeSystem Infrastructure and Application Solutions
- Appliance Servers
- Alpha Servers
- BackOffice Products
- Internet Products
- HPE 9000 and HPE e3000 Servers
- Networking
- Netservers
- Secure OS Software for Linux
- Server Management (Insight Manager 7)
- Windows Server 2003
- Operating System - Tru64 Unix
- ProLiant Deployment and Provisioning
- Linux-Based Community / Regional
- Microsoft System Center Integration
Discussion Boards
Discussion Boards
Discussion Boards
Discussion Boards
Discussion Boards
Discussion Boards
Discussion Boards
Discussion Boards
Discussion Boards
Discussion Boards
Discussion Boards
Discussion Boards
Discussion Boards
Discussion Boards
Discussion Boards
Discussion Boards
Discussion Boards
Discussion Boards
Discussion Boards
Community
Resources
Forums
Blogs
- Subscribe to RSS Feed
- Mark Topic as New
- Mark Topic as Read
- Float this Topic for Current User
- Bookmark
- Subscribe
- Printer Friendly Page
- Mark as New
- Bookmark
- Subscribe
- Mute
- Subscribe to RSS Feed
- Permalink
- Report Inappropriate Content
10-05-2017 08:03 AM
10-05-2017 08:03 AM
E-Fuse error showing on OA for a blade server
One HP BL680c G7 Server in a C7000 chassis is not coming up or being recognised by the the OA. It is reporting an efuse error. We have ssh'ed into the OA and run the following command with no change: "reset bay x" and "reset server x" where x is the bay the server is loacted in.
We have also tried to reseat the server and even changed the bays with no change.
Any pointers to the cause and solution to this issue?
Kindly help...
- Mark as New
- Bookmark
- Subscribe
- Mute
- Subscribe to RSS Feed
- Permalink
- Report Inappropriate Content
11-19-2017 12:00 AM
11-19-2017 12:00 AM
Re: E-Fuse error showing on OA for a blade server
Try to power on the server with minimum config, 1CPU 1Mem, no mezz and check the output.
else you may require replacing the system board.
msh_it | UAE | AbuDhabi
If you feel this was helpful please click the KUDOS! Below!