BladeSystem - General
1745782 Members
3488 Online
108722 Solutions
New Discussion

HP BLADE NICs ISSUE on BL460C G9

 
VP2
Occasional Contributor

HP BLADE NICs ISSUE on BL460C G9

I have C7000 Enclosure G2 which has two blade models HP BL490c G6 and BL460c G9.

I am facing issues with only BL460c G9 as for all the blades NICS are either showing "unknown" or  "Link Down".

But for G6 is all good. 

Virtual Connect FW version is also up to date. I have attached the screenshot of Blade firmware and NIC firmware.

Please suggest some solution.

 

1 REPLY 1
sdmitriev1
Valued Contributor

Re: HP BLADE NICs ISSUE on BL460C G9

You've been using unsupported configuration, your 560FLB isn't supported with any Virtual Connect Module.

There is no one Virtual Connect Module in compability list for 560FLB:

HPE 6125XLG Ethernet Blade Switch
HPE 6127XLG Ethernet Blade Switch
HPE 6120XG Blade Switch
HPE 6120G/XG Blade Switch
HPE 1:10Gb Ethernet BL-c Switch
Cisco Catalyst 3120G Blade Switch for HPE
Cisco Catalyst 3120X Blade Switch for HPE
Cisco Catalyst 3020 Blade Switch
Cisco Fabric Extender B22HP for HPE
HPE GbE2c Layer 2/3 Ethernet Blade Switch
HPE 1GbE Pass Thru Module
10GbE Ethernet Pass-Thru Module
HPE 6125G Ethernet Blade Switch
HPE 6125G/XG Ethernet Blade Switch

http://h20195.www2.hpe.com/v2/redirect.aspx?/products/quickspecs/14331_div/14331_div.PDF