Simpler Navigation for Servers and Operating Systems - Please Update Your Bookmarks
Completed: a much simpler Servers and Operating Systems section of the Community. We combined many of the older boards, so you won't have to click through so many levels to get at the information you need. Check the consolidated boards here as many sub-forums are now single boards.
If you have bookmarked forums or discussion boards in Servers and Operating Systems, we suggest you check and update them as needed.
BladeSystem Server Blades
cancel
Showing results for 
Search instead for 
Did you mean: 

How to install ROM update on HP BL460c Gen 8 using hpsum

SOLVED
Go to solution
luffywallis
Occasional Visitor

How to install ROM update on HP BL460c Gen 8 using hpsum

Hi all;

I updated the C7000 enclosure using hpsum, and it detected my blades as iLo devices, the OA and VC. So i only did the update for iLo in my blades, as well as the update for OA and VC. The installed ROM firmware on my blades is I31 11/02/2014 (not the last version http://h20564.www2.hpe.com/hpsc/swd/public/detail?sp4ts.oid=5177951&swItemId=MTX_1d6eb36c88374db9b71f044ffa&swEnvOid=4166) and i can see the last update in the components of my baseline. So how do i make hpsum detect those updates, and is it possible to do them after the update of OA and VC? Thanks

1 REPLY
Torsten.
Acclaimed Contributor
Solution

Re: How to install ROM update on HP BL460c Gen 8 using hpsum

There are many ways to do this ...

Point HPSUM to the OS IP address of the blades (discover).

If they run a supported OS, you can update firmware and drivers that way.

You should use SPP 2016.10.


Hope this helps!
Regards
Torsten.

__________________________________________________
There are only 10 types of people in the world -
those who understand binary, and those who don't.

__________________________________________________
No support by private messages. Please ask the forum!

If you feel this was helpful please click the KUDOS! thumb below!