Integrity BL860c i2 - can't access ILO

[Darren Etheridge_2]

When trying to access the blade server ILO, I get the message : Unable to start a telnet session.  Reset the hub.

To fix the problem I have to power down the blade server and pull the server out and put it back in the chassis.   Anyone else had this problem and how can we fix it?

Darren

P>S> This thread has been moved from Servers > General to HP BladeSystem Server Blades. - HP Forum Moderator

[Torsten.]

This could be a problem of older firmware. Consider to update to 26.36.

http://h20000.www2.hp.com/bizsupport/TechSupport/SoftwareDescription.jsp?lang=en&cc=us&prodTypeId=3709945&prodSeriesId=4186428&prodNameId=4186429&swEnvOID=54&swLang=8&mode=2&taskId=135&swItem=MTX-d7d83dae38454ceaadaa429706

Bundle Version :26.36

System Firmware Version: 1.95
FPGA Firmware Version: 2.02
iLO-3 Firmware Version: 01.55.02
Power Monitor Firmware Version: 03.04

Don't forget to update the smartarray and the LOMs too:

http://h20000.www2.hp.com/bizsupport/TechSupport/SoftwareDescription.jsp?lang=en&cc=us&prodTypeId=3709945&prodSeriesId=4186428&prodNameId=4186429&swEnvOID=54&swLang=8&mode=2&taskId=135&swItem=MTX-432a0c625ffe4bb58c9ea79a6b

http://h20000.www2.hp.com/bizsupport/TechSupport/SoftwareDescription.jsp?lang=en&cc=us&prodTypeId=3709945&prodSeriesId=4186428&prodNameId=4186429&swEnvOID=54&swLang=8&mode=2&taskId=135&swItem=MTX-ff5406036ec541018bb9713974