Simpler Navigation for Servers and Operating Systems
Completed: a much simpler Servers and Operating Systems section of the Community. We combined many of the older boards, so you won't have to click through so many levels to get at the information you need. Check the consolidated boards here as many sub-forums are now single boards.
BladeSystem Server Blades
cancel
Showing results for 
Search instead for 
Did you mean: 

NPIV is not support in the blade

dennischen
Advisor

NPIV is not support in the blade

Hi, I have a question, in my BL870i4 blade,  interconnect with the pass-through FC switch. And find the NPIV is not supported. Why?

 

ioscan -fknNC fc
Class I H/W Path Driver S/W State H/W Type Description
======================================================================
fc 0 0/0/0/3/0/0/2 fcoc CLAIMED INTERFACE HP 10Gb PCIe 2-port Embedded FCoE Adapter
/dev/fcoc0
fc 1 0/0/0/3/0/0/3 fcoc CLAIMED INTERFACE HP 10Gb PCIe 2-port Embedded FCoE Adapter
/dev/fcoc1
fc 2 0/0/0/4/0/0/2 fcoc CLAIMED INTERFACE HP 10Gb PCIe 2-port Embedded FCoE Adapter
/dev/fcoc2
fc 3 0/0/0/4/0/0/3 fcoc CLAIMED INTERFACE HP 10Gb PCIe 2-port Embedded FCoE Adapter
/dev/fcoc3
fc 6 1/0/0/4/0/0/2 fcoc CLAIMED INTERFACE HP 10Gb PCIe 2-port Embedded FCoE Adapter
/dev/fcoc6
fc 7 1/0/0/4/0/0/3 fcoc CLAIMED INTERFACE HP 10Gb PCIe 2-port Embedded FCoE Adapter
/dev/fcoc7

 

depot]#fcmsutil /dev/fcoc6

Vendor ID is = 0x19a2
Device ID is = 0x0714
PCI Sub-system Vendor ID is = 0x103c
PCI Sub-system ID is = 0x177b
Chip version = 1
Firmware and EFI Package version = 4.9.416.12
EFI Boot = ENABLED
Driver-Firmware Dump Available = NO
Driver-Firmware Dump Timestamp = N/A
Previous Topology = UNINITIALIZED
Link Speed = UNKNOWN
Allocated Link Bandwidth = N/A
Local N_Port_id is = None
Previous N_Port_id is = None
N_Port Node World Wide Name = 0x20001c98ec106d97
N_Port Port World Wide Name = 0x10001c98ec106d97
Switch Port World Wide Name = 0x0000000000000000
Switch Node World Wide Name = 0x0000000000000000
N_Port Symbolic Port Name = hpvm_fcoc6
N_Port Symbolic Node Name = hpvm_HP-UX_B.11.31
Driver state = AWAITING_LINK_UP
Hardware Path is = 1/0/0/4/0/0/2
Maximum Frame Size = 2048
TYPE = PFC
NPIV Supported = NO
Driver Version = @(#) FCOC: PCIe Fibre Channel driver (FibrChanl-03), B.11.31.1505, Jan 14 2016, FCOC_IFC (4,1)

1 REPLY
Robert_Jewell
Honored Contributor

Re: NPIV is not support in the blade

This may be stating this as the link is not configured yet.  

-Bob

----------------
Was this helpful? Like this post by giving me a thumbs up below!