BladeSystem Server Blades

OA: Blade 6: Mezz card internal data problem for Mezz #2

 
rmay_bk
Valued Contributor

OA: Blade 6: Mezz card internal data problem for Mezz #2

Hi all, I have a Gen 9 blade that's exhibiting this exact problem.  I've replaced the mezz card, reset Virtual Connect, e-fused the blade, and reset the BIOS/CMOS to factory defaults.  No help.  Also performed all of the steps in the kb article and tried applying the latest SPP.

Jan 21 17:00:28 OA: Blade 6: Mezz card internal data problem for Mezz #2.
Jan 21 17:00:29 OA: Blade 6: Mezz card internal data problem for Mezz #2.
Jan 21 17:00:34 OA: Blade 6: Mezz card internal data problem for Mezz #2.
Jan 21 17:03:36 OA: Blade 6: Mezz card internal data problem for Mezz #2.
Jan 21 17:33:59 OA: Blade in bay 6 has been powered down
Jan 21 17:34:00 OA: Blade 6: Mezz card internal data problem for Mezz #2.
Jan 21 17:34:06 OA: Blade in bay 6 has been powered on
Jan 21 17:41:00 OA: Blade in bay 6 has been powered down
Jan 21 17:41:01 OA: Blade 6: Mezz card internal data problem for Mezz #2.

Any thoughts on how to diagnose?

3 REPLIES 3
support_s
System Recommended

Query: Server state UNKNOWN, Cause: Hardware status of enc0:dev6 is reported as degraded by OA

System recommended content:

1. HPE ProLiant DL380 Gen10 Server - Network status is showing Unknown in iLO5

 

If the above information is helpful, then please click on "Thumbs Up/Kudo" icon.

 

Thank you for being a HPE community member.


Accept or Kudo

gcj2021
Occasional Advisor

Re: OA: Blade 6: Mezz card internal data problem for Mezz #2

Was the response to this the solution? Reading through the solution not only does it say Gen10/Gen10Plus, but seems it is more of a ESXi vib - I'm having the same issue as you did/are on a G9 blade and curious your solution. Thanks!

Sunitha_G
Moderator

Re: OA: Blade 6: Mezz card internal data problem for Mezz #2

Hello @gcj2021

Thank you for posting! Since you have posted in an old topic and there is no response yet, I would recommend you to create a new topic using the create "New Discussion" button.

Thanks,
Sunitha G
I'm an HPE employee.

Accept or Kudo