Simpler Navigation for Servers and Operating Systems - Please Update Your Bookmarks
Completed: a much simpler Servers and Operating Systems section of the Community. We combined many of the older boards, so you won't have to click through so many levels to get at the information you need. Check the consolidated boards here as many sub-forums are now single boards.
If you have bookmarked forums or discussion boards in Servers and Operating Systems, we suggest you check and update them as needed.
BladeSystem Server Blades
Showing results for 
Search instead for 
Did you mean: 

Port MAP for C7000 with BL8x0 i2 and Quad Port Mezz Card

Trusted Contributor

Port MAP for C7000 with BL8x0 i2 and Quad Port Mezz Card

Hieu had a port mapping question:




One question regarding port mapping on BL460c GEN8 using C7000 Enclosure.

If I put the 1Gb 4-port 366M Adapter into Mezzanine Slot 1 on BL460c GEN8. I’m not sure whether this 4-port Adapter route to interconnect bay 3 & 4 or  interconnect bay 3, 4, 5 & 6.

Could someone help to confirm for this?




Input from Diane:




That doesn’t change on the Gen8 from the G7.  Mezz slot 1 maps to slots 3 & 4.  You have to go to slot 2 if you want to use a 4 port option.


This is in the Quick Specs:

Form factor

Type I mezzanine card compatible with all ProLiant c-Class Gen8 servers listed in the Supported Servers section of this QuickSpecs, all mezzanine slots. Multiple cards per server.
NOTE: If the 366M is installed in mezzanine slot 1 of a half-height server, connectivity will be provided on only 2 of the 4 ports.


Look here as well:

Page 8-9 on HP Integrity BL860c i2, BL870c i2 & BL890c Installation Guide