- Community Home
- >
- Servers and Operating Systems
- >
- HPE BladeSystem
- >
- BladeSystem - General
- >
- Re: Windows Server 2008 R2 won't boot after instal...
Categories
Company
Local Language
Forums
Discussions
Forums
- Data Protection and Retention
- Entry Storage Systems
- Legacy
- Midrange and Enterprise Storage
- Storage Networking
- HPE Nimble Storage
Discussions
Discussions
Discussions
Forums
Discussions
Discussion Boards
Discussion Boards
Discussion Boards
Discussion Boards
- BladeSystem Infrastructure and Application Solutions
- Appliance Servers
- Alpha Servers
- BackOffice Products
- Internet Products
- HPE 9000 and HPE e3000 Servers
- Networking
- Netservers
- Secure OS Software for Linux
- Server Management (Insight Manager 7)
- Windows Server 2003
- Operating System - Tru64 Unix
- ProLiant Deployment and Provisioning
- Linux-Based Community / Regional
- Microsoft System Center Integration
Discussion Boards
Discussion Boards
Discussion Boards
Discussion Boards
Discussion Boards
Discussion Boards
Discussion Boards
Discussion Boards
Discussion Boards
Discussion Boards
Discussion Boards
Discussion Boards
Discussion Boards
Discussion Boards
Discussion Boards
Discussion Boards
Discussion Boards
Discussion Boards
Discussion Boards
Community
Resources
Forums
Blogs
- Subscribe to RSS Feed
- Mark Topic as New
- Mark Topic as Read
- Float this Topic for Current User
- Bookmark
- Subscribe
- Printer Friendly Page
- Mark as New
- Bookmark
- Subscribe
- Mute
- Subscribe to RSS Feed
- Permalink
- Report Inappropriate Content
10-16-2018 08:54 PM
10-16-2018 08:54 PM
Windows Server 2008 R2 won't boot after install on HP ProLiant BL460c G6
I created a bootable SmartStart USB drive, then I copied the retail Windows Server 2008 R2 iso to the root of the USB drive. I booted off the SmartStart USB drive and I was able to install Windows Server 2008 R2. Sadly, Windows won't boot. The blade tries to boot from the NIC. I even did a one time boot option and selected boot from internal HDD. Yet, the blade still won't boot.
- Mark as New
- Bookmark
- Subscribe
- Mute
- Subscribe to RSS Feed
- Permalink
- Report Inappropriate Content
10-17-2018 07:55 AM
10-17-2018 07:55 AM
Re: Windows Server 2008 R2 won't boot after install on HP ProLiant BL460c G6
The Server try to boot from NIC, if there is no bootable Disk Drive.
Boot again from the USB and enter Setup.
Check if it list an Installed OS and if it set as Bootable.
From the Windows Setup you can go to the Commandline and check the Disk with Diskpart.
(Google for: windows setup diskpart)