BladeSystem - General
1745847 Members
4359 Online
108723 Solutions
New Discussion

hp-ux time vs blade enclosure time -- how to check verify.

 
rveri-admin
Frequent Advisor

hp-ux time vs blade enclosure time -- how to check verify.

Hi Experts,

 

Server                 : HP-UX 11.31  BL890C

Blade Enclosure: BladeSystem c7000 Enclosure G2

 

On the server hp-ux side I can see the times in syslog,   and  the same I would like to see the enclosure syslog timings occuring on the blade : BL890C C7000 enclosure.

 

I am having feeling the time shows by syslog on  Enclosure has a different time, and may not be in EST time zone,

 

On the server side I see right now:

Wed Jan  8 13:12:17 EST 2014

 

How to verify the enclosure time: So that to diagnose error and alert times,

 

 

Thanks,..

 

 

P.S. This thread has been moevd from HP-UX > System Administration to HP BladeSystem Server Blades. - Hp Forum Moderator

 

 

 

2 REPLIES 2
rveri-admin
Frequent Advisor

Re: hp-ux time vs blade enclosure time -- how to check verify.

I have seen a time stamp of some failure on the enclosure side , how to know if it is UTC/GMT or EST timezone. 

 


Jan 8 02:21:07 OA: PS Subsystem Overload - FAILED. Allocated Power: 6400W DC, Present Power: 3716W AC.
Jan 8 02:21:07 OA: PS Subsystem N + N Redundancy - FAILED. Allocated Power: 6400W DC, Present Power: 3716W AC.

Robert_Jewell
Honored Contributor

Re: hp-ux time vs blade enclosure time -- how to check verify.

Access the OA and view Enclosure Settings and then select Date and Time.  Or, from the OA CLI run the command 'show date'.

 

 

-Bob

----------------
Was this helpful? Like this post by giving me a thumbs up below!