BladeSystem Storage Blades
Showing results for 
Search instead for 
Did you mean: 

HP storage blade D2200sb boot question.

Trusted Contributor

HP storage blade D2200sb boot question.

Irit had a customer question on the D2200sb storage blade:




I have a customer, who has an issue with the HP storage blade D2200sb:


I have host blade connected with storage blade D2200sb (e.g.: bay1 and bay2),

When I’m trying to install Linux OS on the host blade, I found that when OS scan the bus, the storage blade get to be mapped first and only then the local drives on the host,



Storage blade has 4 drives in Raid1/0 – (2TB)

Local drives are in Riad1 – (146GB)



When we using our automatic OS installation, this is probably the reason why the OS installed by default on the storage blade rather than the local drives (which we desire to install on local drives rather than on storage blade)


My question: Is there a way to set the bus scan of the OS (maybe via BIOS settings) in a way that the local hard drives will get to be the first to be scanned?

(So local drives will get /cciss/c0d0)




Help from Dave:




They should be able to set the internal Embedded array to boot first by changing the Boot Controller order in the ROMBIOS.


It would look something like this:








I hope that helps. Any other comments or suggestions for Irit?


Occasional Visitor

Re: HP storage blade D2200sb boot question.

How do you do this on G9 with UEFI enabled?

Acclaimed Contributor

Re: HP storage blade D2200sb boot question.

This storage blade is not supported by Gen9 servers.

Consider to open a new thread.

Is "how to configure boot order in UEFI" the question?

Hope this helps!

There are only 10 types of people in the world -
those who understand binary, and those who don't.

No support by private messages. Please ask the forum!

If you feel this was helpful please click the KUDOS! thumb below!