Simpler Navigation for Servers and Operating Systems
Completed: a much simpler Servers and Operating Systems section of the Community. We combined many of the older boards, so you won't have to click through so many levels to get at the information you need. Check the consolidated boards here as many sub-forums are now single boards.
BladeSystem Storage Blades
cancel
Showing results for 
Search instead for 
Did you mean: 

Update SB40C blade in c3000 enclosure

Alice Seeley
Frequent Advisor

Update SB40C blade in c3000 enclosure

I have a customer with a c3000 enclosure with OA firmware 3.55 and I am recommending that they update to 3.71. I notice that they have an SB40c storage blade also that is at fw version 1.20. Where do I find the recommended version for that blade that is compatible with 3.71 OA firmware and how do we go about updating the SB40c blade?

2 REPLIES
Robert_Jewell
Honored Contributor

Re: Update SB40C blade in c3000 enclosure

I found the following fromt the SB40c support page:

http://h20000.www2.hp.com/bizsupport/TechSupport/Home.jsp?lang=en&cc=us&taskId=&prodSeriesId=3236380&prodTypeId=329290

 

Select the "Guided Troubleshooting" section and you will see a section about updating firmware:

 

----------------------------------------------

SB40c Storage Blade firmware is already embedded in the OA firmware code.  From OA CLI run the following command:

 

>SHOW UPDATE

 

A table showing components, current and new firmware versions will be displayed.

 

To update the firmware on SB40c Storage Blade, run the command

 

>UPDATE DEVICE XX

 

Where XX stands for location.

---------------------------------------------

 

Basically, you perform the OA update and then  run the SHOW UPDATE and UPDATE DEVICE commands from the OA CLI to update the Storage Blade (as well as any Pass Through modules you may have).

 

Also, note that the SB40c has an embedded P400 controller that you can update via the partner blade OS.   

 

 

-Bob

----------------
Was this helpful? Like this post by giving me a thumbs up below!
Highlighted
Alice Seeley
Frequent Advisor

Re: Update SB40C blade in c3000 enclosure

Thank you for your guidance. It sounds easy enough, won't be able to tell until I am at the customer to do the work. I am also still unsure about the p400 controller that will get updated from the partner blade. Thank you gor pointing in the right place for information.