HPE Community read-only access December 15, 2018
This is a maintenance upgrade. You will be able to read articles and posts, but not post or reply.
Hours:
Dec 15, 4:00 am to 10:00 am UTC
Dec 14, 10:00 pm CST to Dec 15, 4:00 am CST
Dec 14, 8:00 pm PST to Dec 15, 2:00 am PST
BladeSystem Virtual Connect
cancel
Showing results for 
Search instead for 
Did you mean: 

Best practice to connect one IRF member to a c7000 enclosure with Virtual Connect.

 
mekand
Occasional Advisor

Best practice to connect one IRF member to a c7000 enclosure with Virtual Connect.

A costumer of mine has an IRF stack where one member resides on site A and the other member resides on site B. On site A, there is an enclosure with two VC ethernet module, one into bay 1 and one into bay2. VCs are already configured for active/standby. There are four uplinks from one member to one enclosure, so I believe I need to configure two link aggregations: one for VC on bay 1 and one for VC on bay 2.
Right?
Thanks.

1 REPLY
bakerbas
Advisor

Re: Best practice to connect one IRF member to a c7000 enclosure with Virtual Connect.

Yea - 2 link aggs.

Please check out the Virtual Connect Cookbooks - they will give good details on what and how to configure on VC

Example - http://h20628.www2.hp.com/km-ext/kmcsdirect/emr_na-c03808925-4.pdf