- Community Home
- >
- Servers and Operating Systems
- >
- HPE BladeSystem
- >
- BladeSystem - General
- >
- Re: Boot from SAN using RHEL 6.6 + HP BL460c Gen9 ...
Categories
Company
Local Language
Forums
Discussions
Forums
- Data Protection and Retention
- Entry Storage Systems
- Legacy
- Midrange and Enterprise Storage
- Storage Networking
- HPE Nimble Storage
Discussions
Discussions
Discussions
Forums
Discussions
Discussion Boards
Discussion Boards
Discussion Boards
Discussion Boards
- BladeSystem Infrastructure and Application Solutions
- Appliance Servers
- Alpha Servers
- BackOffice Products
- Internet Products
- HPE 9000 and HPE e3000 Servers
- Networking
- Netservers
- Secure OS Software for Linux
- Server Management (Insight Manager 7)
- Windows Server 2003
- Operating System - Tru64 Unix
- ProLiant Deployment and Provisioning
- Linux-Based Community / Regional
- Microsoft System Center Integration
Discussion Boards
Discussion Boards
Discussion Boards
Discussion Boards
Discussion Boards
Discussion Boards
Discussion Boards
Discussion Boards
Discussion Boards
Discussion Boards
Discussion Boards
Discussion Boards
Discussion Boards
Discussion Boards
Discussion Boards
Discussion Boards
Discussion Boards
Discussion Boards
Discussion Boards
Community
Resources
Forums
Blogs
- Subscribe to RSS Feed
- Mark Topic as New
- Mark Topic as Read
- Float this Topic for Current User
- Bookmark
- Subscribe
- Printer Friendly Page
- Mark as New
- Bookmark
- Subscribe
- Mute
- Subscribe to RSS Feed
- Permalink
- Report Inappropriate Content
04-23-2015 03:12 AM
04-23-2015 03:12 AM
Boot from SAN using RHEL 6.6 + HP BL460c Gen9 + HP 630FLB + EMC storage
Hi,
we are unable to boot from SAN X with RHEL 6.6 on blade servers
HP BL460c Gen9 + HP 630FLB using EMC storage. We have a lot of
other FCoE adapters booting from SAN, these servers are the
first ones with this Broadcom CNA.
Does somene has a similar setup?
Thank you,
best regards,
- Mark as New
- Bookmark
- Subscribe
- Mute
- Subscribe to RSS Feed
- Permalink
- Report Inappropriate Content
04-23-2015 08:39 AM
04-23-2015 08:39 AM
Re: Boot from SAN using RHEL 6.6 + HP BL460c Gen9 + HP 630FLB + EMC storage
Hi Pinco,
Are you using Virtual connect in the interconnect bays in the enclosure & what is the storage that you are using ?
If it is virtual connect, have you added the FC Boot Parameters in the SAN Profile and check ?
Suresh
I work for Hp
- Mark as New
- Bookmark
- Subscribe
- Mute
- Subscribe to RSS Feed
- Permalink
- Report Inappropriate Content
04-27-2015 07:37 PM
04-27-2015 07:37 PM
Re: Boot from SAN using RHEL 6.6 + HP BL460c Gen9 + HP 630FLB + EMC storage
Hi el pinco
Unfortunately EMC do not support Broadcom based Converged Network Adaptors.
Here is an knowledge base article (will require a valid login to the EMC portal)
192744 : VPLEX: Storage cannot be accessed by ESX 5.x hosts provisioned from VPLEX when using the Broadcom NetXtreme II 57810 CNA series of adaptors
https://support.emc.com/kb/192744
Leonard...