- Community Home
- >
- Servers and Operating Systems
- >
- HPE BladeSystem
- >
- BladeSystem - General
- >
- C3000 chassis and VC-Fibre Channel module in Bay 2
Categories
Company
Local Language
Forums
Discussions
Forums
- Data Protection and Retention
- Entry Storage Systems
- Legacy
- Midrange and Enterprise Storage
- Storage Networking
- HPE Nimble Storage
Discussions
Discussions
Discussions
Forums
Discussions
Discussion Boards
Discussion Boards
Discussion Boards
Discussion Boards
- BladeSystem Infrastructure and Application Solutions
- Appliance Servers
- Alpha Servers
- BackOffice Products
- Internet Products
- HPE 9000 and HPE e3000 Servers
- Networking
- Netservers
- Secure OS Software for Linux
- Server Management (Insight Manager 7)
- Windows Server 2003
- Operating System - Tru64 Unix
- ProLiant Deployment and Provisioning
- Linux-Based Community / Regional
- Microsoft System Center Integration
Discussion Boards
Discussion Boards
Discussion Boards
Discussion Boards
Discussion Boards
Discussion Boards
Discussion Boards
Discussion Boards
Discussion Boards
Discussion Boards
Discussion Boards
Discussion Boards
Discussion Boards
Discussion Boards
Discussion Boards
Discussion Boards
Discussion Boards
Discussion Boards
Discussion Boards
Community
Resources
Forums
Blogs
- Subscribe to RSS Feed
- Mark Topic as New
- Mark Topic as Read
- Float this Topic for Current User
- Bookmark
- Subscribe
- Printer Friendly Page
- Mark as New
- Bookmark
- Subscribe
- Mute
- Subscribe to RSS Feed
- Permalink
- Report Inappropriate Content
10-13-2011 06:50 AM
10-13-2011 06:50 AM
C3000 chassis and VC-Fibre Channel module in Bay 2
Brian had an interconnect configuration question on the c3000 chassis:
******************
Can anyone tell me if it is supported to put FC HBA cards in MEZZ1 and put and VC-FC module in bay 2 of a C3000 with a VC-Ethernet module in bay 1 for a customer’s noncritical dev environment?
********************
From Terri:
The c3000 port mapping will show you all embedded NIC port go out interconnect bay 1, so this is where the VC-Ethernet module needs to be. I assume that's what you meant by VC-ETH mod bay 1.
With a FC HBA card in mezz slot 1, both of the ports do go out the one interconnect bay 2 (unlike the c7000).
So its not only supported, its how you would do it with one FC HBA in a c3000.
From Lee:
You cannot put a Virtual Connect FC module in Bay 2. See the latest Virtual Connect Setup and Installation Guide for the rules. For the 5th edition, the rules start on page 39. There is a table showing supported C3000 configurations on page 42.
From Hoa:
Here is the c3000 interconnect mappings and supported configurations.
*********************
Comments or suggestions?