HPE Community read-only access December 15, 2018
This is a maintenance upgrade. You will be able to read articles and posts, but not post or reply.
Hours:
Dec 15, 4:00 am to 10:00 am UTC
Dec 14, 10:00 pm CST to Dec 15, 4:00 am CST
Dec 14, 8:00 pm PST to Dec 15, 2:00 am PST
BladeSystem Virtual Connect
cancel
Showing results for 
Search instead for 
Did you mean: 

Cannot get "Virtual Connect Domain IP Address" to work

 
SOLVED
Go to solution
NJK-Work
Honored Contributor

Cannot get "Virtual Connect Domain IP Address" to work

I have some older Virtual Connects that I just realized the "Virtual Connect Domain IP Address" I had configured is not working - I don't think it ever worked - but I just noticed it now.

 

The model is "HP 1/10Gb VC-Enet Module" for Ethernet and "HP 4Gb VC-FC Module" for the SAN module.  The current firmware is "2.32".  I was thinking about updating the firmware and when checking them out to see where we were at, is when I noticed the IP address I assigned for the "Virtual Connect Domain IP Address" was not working.  I cannot connect to it via a web browser and I cannot ping the IP address.  When I connect to the primary ethernet module via it's IP address, I can see the that the 'Virtual Connect Domain IP Address" is set "correctly.  It has a valid IP address and the correct subnet and GW.  I tried to click the "Apply" button to force it to re-initialize, but that had no affect.

 

Anyone have any ideas.

Thanks

Nelson

1 REPLY
NJK-Work
Honored Contributor
Solution

Re: Cannot get "Virtual Connect Domain IP Address" to work

I disabled "Virtual Connect Domain IP Address" (unchecked the box) and saved it.  Then I re-eabled it using the same IP information as before and saved it.  Now it works.

 

Nelson