Centos 7.0.1406 does not see FlexFabric NIC's during install

[msteele]

Yep - I'm positive they all match.

[frenchy94]

Try swift boot device between blade to see if issue follow Balde or OS
please



---
L'absence de virus dans ce courrier électronique a été vérifiée par le logiciel antivirus Avast.
https://www.avast.com/antivirus

[Jimmy Vance]

If I recall there is a setting in the ROM whre the blade itself can override some OA / VC type settings.   I'd suggest using maintenance SW6 to reset the ROM to default

[msteele]

Thank you for the suggestion - I don't know what swift boot refers to. I also don't have any other blades that are not in production at this time.

I built two blades in the past 48 hours that match the same firmware / ROM - this is only this blade that is having the issue.

I could try moving it to another slot in the chassis to see if that makes a difference.

Are there any know BIOS settings that would cause a NIC to not be recognized by the OS during installation?

[msteele]

Thank you - is that accessed via the ILO web interface or via the BIOS / F9, etc.?

[frenchy94]

You see Nic0 and Nic1 so you see physical nic



---
L'absence de virus dans ce courrier électronique a été vérifiée par le logiciel antivirus Avast.
https://www.avast.com/antivirus

[msteele]

That is correct - when I start to install the OS I can see eth0 and eth1  - but not the remaining nics.

[frenchy94]

Remaining nic are created by firmware/Virtual connect , that split 2
physical nic to up 8 virtual nic so

Problem can be

Nic

Firmware nic

Driver nic

Vc

That's all



---
L'absence de virus dans ce courrier électronique a été vérifiée par le logiciel antivirus Avast.
https://www.avast.com/antivirus