- Community Home
- >
- Servers and Operating Systems
- >
- HPE BladeSystem
- >
- BladeSystem - General
- >
- Connection to Aruba 2920 Stacking Switches
Categories
Company
Local Language
Forums
Discussions
Forums
- Data Protection and Retention
- Entry Storage Systems
- Legacy
- Midrange and Enterprise Storage
- Storage Networking
- HPE Nimble Storage
Discussions
Discussions
Discussions
Forums
Discussions
Discussion Boards
Discussion Boards
Discussion Boards
Discussion Boards
- BladeSystem Infrastructure and Application Solutions
- Appliance Servers
- Alpha Servers
- BackOffice Products
- Internet Products
- HPE 9000 and HPE e3000 Servers
- Networking
- Netservers
- Secure OS Software for Linux
- Server Management (Insight Manager 7)
- Windows Server 2003
- Operating System - Tru64 Unix
- ProLiant Deployment and Provisioning
- Linux-Based Community / Regional
- Microsoft System Center Integration
Discussion Boards
Discussion Boards
Discussion Boards
Discussion Boards
Discussion Boards
Discussion Boards
Discussion Boards
Discussion Boards
Discussion Boards
Discussion Boards
Discussion Boards
Discussion Boards
Discussion Boards
Discussion Boards
Discussion Boards
Discussion Boards
Discussion Boards
Discussion Boards
Discussion Boards
Community
Resources
Forums
Blogs
- Subscribe to RSS Feed
- Mark Topic as New
- Mark Topic as Read
- Float this Topic for Current User
- Bookmark
- Subscribe
- Printer Friendly Page
- Mark as New
- Bookmark
- Subscribe
- Mute
- Subscribe to RSS Feed
- Permalink
- Report Inappropriate Content
01-20-2019 07:27 AM
01-20-2019 07:27 AM
Connection to Aruba 2920 Stacking Switches
We have 2 HPE Flex 10/10D Module in C7000 and Bay 1 X1 is connected to Stack SW1, Bay X2 is connected to Stack SW2.
We have 2 uplink sets using these exit ports and I enabled smart link.
In switch side, there is trunk lacp defined for these two ports connected to two flex modules.
My problem is that when I reboot the swtich connected to Active Flex module, I lost connection for more than 30 seconds. When switch is up but not 100% ready, Virtual Connect see that port as Linked and making it Linked Active again, it failed.
How should be the configuration? (is there a way to configure VC not to take over Active as soon as link is up) Could you please help?
Thanks a lot in advance
- Mark as New
- Bookmark
- Subscribe
- Mute
- Subscribe to RSS Feed
- Permalink
- Report Inappropriate Content
01-21-2019 04:50 AM
01-21-2019 04:50 AM
Re: Connection to Aruba 2920 Stacking Switches
Hello,
This will required deep analysis, please open a support case on this matter.
Thanks