- Community Home
- >
- Servers and Operating Systems
- >
- HPE BladeSystem
- >
- BladeSystem - General
- >
- Direct connect Netapp to Virtual Connect Flex-10 m...
Categories
Company
Local Language
Forums
Discussions
Forums
- Data Protection and Retention
- Entry Storage Systems
- Legacy
- Midrange and Enterprise Storage
- Storage Networking
- HPE Nimble Storage
Discussions
Discussions
Discussions
Forums
Discussions
Discussion Boards
Discussion Boards
Discussion Boards
Discussion Boards
- BladeSystem Infrastructure and Application Solutions
- Appliance Servers
- Alpha Servers
- BackOffice Products
- Internet Products
- HPE 9000 and HPE e3000 Servers
- Networking
- Netservers
- Secure OS Software for Linux
- Server Management (Insight Manager 7)
- Windows Server 2003
- Operating System - Tru64 Unix
- ProLiant Deployment and Provisioning
- Linux-Based Community / Regional
- Microsoft System Center Integration
Discussion Boards
Discussion Boards
Discussion Boards
Discussion Boards
Discussion Boards
Discussion Boards
Discussion Boards
Discussion Boards
Discussion Boards
Discussion Boards
Discussion Boards
Discussion Boards
Discussion Boards
Discussion Boards
Discussion Boards
Discussion Boards
Discussion Boards
Discussion Boards
Discussion Boards
Community
Resources
Forums
Blogs
- Subscribe to RSS Feed
- Mark Topic as New
- Mark Topic as Read
- Float this Topic for Current User
- Bookmark
- Subscribe
- Printer Friendly Page
- Mark as New
- Bookmark
- Subscribe
- Mute
- Subscribe to RSS Feed
- Permalink
- Report Inappropriate Content
03-08-2013 07:42 AM
03-08-2013 07:42 AM
Direct connect Netapp to Virtual Connect Flex-10 module
Avi had a customer question:
******************
Is it SUPPORTED to connect Netapp FAS3160 directly to Flex10 via Ethernet .
The Netapp have 2 controllers, each controller to separate Flex10.
The ports speed 1GB.
**************
Reply from Jim:
***************
While it may be possible( I have customers who have tried this with varying degrees of success) to achieve connectivity with Flex-10 module via direct connect on a NetApp it is not a supported configuration.
*************
Input from Cullen:
**************
You can connect any Ethernet device you want directly to a Flex-10 uplink, but you need to be aware of the limitations and features of that link. In particular:
- Virtual Connect is not a switch and does not act like a standard switch.
- Virtual Connect will not pass packets that come in on one uplink port to another uplink port. Anything attached directly to an uplink port will only be reachable from systems within the VC domain and only if they are connected to the network assigned for this external device.
- If you assign two uplink ports to the same uplink set, one will be active and the other standby. This may cause issues if the external device wants to send traffic through the standby connection.
*************
Other comments or questions?