HPE Community
BladeSystem - General
1752861 Members
4099 Online
108791 Solutions
New Discussion

Re: Emulex lpfc message with g7 blade and VirtualConnect

 
Ulf Zimmermann
Frequent Advisor

‎02-09-2011 10:41 PM

‎02-09-2011 10:41 PM

Re: Emulex lpfc message with g7 blade and VirtualConnect

But then there are longer gaps too. Hmmmm
0 Kudos
Reply
Johan Guldmyr
Honored Contributor

‎02-09-2011 10:44 PM

‎02-09-2011 10:44 PM

Re: Emulex lpfc message with g7 blade and VirtualConnect

Guess that makes it less likely that the driver could be the issue. But might be worth a shot anyway.

And that's quite a lot, that will fill up the logs pretty fast :/

Is it always the same NPORT that are being reported? On all machines?

Maybe we can find something in common for them. Like which devices/ports are sending these 'xf' commands.

Maybe these NPORTs can be located - if the x21500 for example is an address?
0 Kudos
Reply
The opinions expressed above are the personal opinions of the authors, not of Hewlett Packard Enterprise. By using this site, you accept the Terms of Use and Rules of Participation.