- Community Home
- >
- Servers and Operating Systems
- >
- HPE BladeSystem
- >
- BladeSystem - General
- >
- Error mixing VC Flex-10 with Brocade SAN switch at...
Categories
Company
Local Language
Forums
Discussions
Forums
- Data Protection and Retention
- Entry Storage Systems
- Legacy
- Midrange and Enterprise Storage
- Storage Networking
- HPE Nimble Storage
Discussions
Discussions
Discussions
Forums
Discussions
Discussion Boards
Discussion Boards
Discussion Boards
Discussion Boards
- BladeSystem Infrastructure and Application Solutions
- Appliance Servers
- Alpha Servers
- BackOffice Products
- Internet Products
- HPE 9000 and HPE e3000 Servers
- Networking
- Netservers
- Secure OS Software for Linux
- Server Management (Insight Manager 7)
- Windows Server 2003
- Operating System - Tru64 Unix
- ProLiant Deployment and Provisioning
- Linux-Based Community / Regional
- Microsoft System Center Integration
Discussion Boards
Discussion Boards
Discussion Boards
Discussion Boards
Discussion Boards
Discussion Boards
Discussion Boards
Discussion Boards
Discussion Boards
Discussion Boards
Discussion Boards
Discussion Boards
Discussion Boards
Discussion Boards
Discussion Boards
Discussion Boards
Discussion Boards
Discussion Boards
Discussion Boards
Community
Resources
Forums
Blogs
- Subscribe to RSS Feed
- Mark Topic as New
- Mark Topic as Read
- Float this Topic for Current User
- Bookmark
- Subscribe
- Printer Friendly Page
- Mark as New
- Bookmark
- Subscribe
- Mute
- Subscribe to RSS Feed
- Permalink
- Report Inappropriate Content
12-06-2012 02:03 PM
12-06-2012 02:03 PM
Error mixing VC Flex-10 with Brocade SAN switch at C3000
Chielsin had a problem with interconect modules on a c3000 enclosure:
**************
I mix VC Flex-10 (bay 1) and Brocade SAN switch (bay 2) in a C3000 enclosure using SBW-Configurator, and got below error. (Usually no error)
As far as I know, the only limitation is in interconnect bay1, we must put Ethernet interconnect only.
There is no explanation about this at quickspec too.
Do we have this limitation of mixing interconnect?
****************
Input from Marc:
***************
This is against the enclosure population rules for the c3000:
“The use of an HP VC-Enet in bay 1 and a Fibre Channel module (for example, VC-FC, SNA
switch, or FC pass-thru) in bay 2 is not supported in c3000 enclosures.”
Page 17 of the “HP Virtual Connect for c-Class BladeSystem Setup and Installation Guide” here: http://bizsupport1.austin.hp.com/bc/docs/support/SupportManual/c01732252/c01732252.pdf
***************
And info from Fred:
**************
The SIG Marc mentioned indicates this restriction isn’t just for C3000 enclosures. The table on pages 18 and 19 explains valid and invalid combinations of modules in horizontally adjacent bays and has the following statement in the last row: “Do not mix VC and non-VC (switch or pass-thru) modules in horizontally adjacent bays.”
**************
Comments?