BladeSystem Virtual Connect
cancel
Showing results for 
Search instead for 
Did you mean: 

FlexFabric Configuration

chelin_h2
Occasional Visitor

FlexFabric Configuration

Hi People, I hope you can help me,. actually i'm using a FlexFabric in my c7000 enclosure, this FlexFabric is conected to 10 Gbps in x5 and X6 port.
now I want to add a new uplink in x7 using a SFP-RJ45 1 Gb. is this posible? I´m clear that i will lost one stacking link port, but i need to add dmz to this enclosure, what do you think about this configuration?

 

In advance Many Thnaks !
And sorry for my write mistakes! (From Chile)

2 REPLIES
pyzze
Occasional Advisor

Re: FlexFabric Configuration

Hi,

You can check FlexFabric 10Gb/24-Port Module quickspecs here:

http://www8.hp.com/h20195/v2/GetPDF.aspx/c04154400.pdf

Ports X5 to X9 can be used either for 1 or 10Gb Ethernet (SFP+). According to the same document, this is the 1 Gb SFP supported:

HP BladeSystem c-Class Virtual Connect 1G SFP RJ-45 Transceiver 453154-B21

And yes, you will lose one stacking link port.

Regards,

JA

msh_it
Frequent Advisor

Re: FlexFabric Configuration

Hi

Yes you will loose one stacking link, but it will work for sure.

-------------------------------

msh_it | UAE | AbuDhabi

If you feel this was helpful please click the KUDOS! Below!