HPE Community read-only access December 15, 2018
This is a maintenance upgrade. You will be able to read articles and posts, but not post or reply.
Hours:
Dec 15, 4:00 am to 10:00 am UTC
Dec 14, 10:00 pm CST to Dec 15, 4:00 am CST
Dec 14, 8:00 pm PST to Dec 15, 2:00 am PST
BladeSystem Virtual Connect
cancel
Showing results for 
Search instead for 
Did you mean: 

Format of "load ssh" key files

 
ilouser
Occasional Advisor

Format of "load ssh" key files

What's the required format of the SSH key for the "load ssh" command? I'm using a normal SSH id_dsa.pub format, i.e.: ssh-dss AAAaAHsfhgsdhgeiglksjdfglslfgsdlfjglsdhfglsjdfaqH9QTIu0Rz0 user@host I've tried replacing user@host with Administrator the way ILO2 likes it, no deal. ->load ssh Address=ftp://ftpuser:password@149.150.151.152FileName=/tftpboot/ssh_key_vc.pub ERROR: Unable to configure the SSH key Running a packet snoop it actually ftps in and gets the file, but then barfs on it. I'm logged into the VC as Administrator ta, Mark.
1 REPLY
ilouser
Occasional Advisor

Format of "load ssh" key files

Ok, so the packet snoop wasn't quite snoopy enough... FTP: "550 tftpboot/ssh_key_vc.pub: No such file or directory.\r\n" This works: ->load ssh Address=ftp://ftpuser:password@149.150.151.152FileName=//tftpboot/ssh_key_vc.pub I'd say that was a VC bug :)