- Community Home
- >
- Servers and Operating Systems
- >
- HPE BladeSystem
- >
- BladeSystem - General
- >
- HP VC FlexFabric-20/40 F8 connect with Cisco Nexus...
Categories
Company
Local Language
Forums
Discussions
Forums
- Data Protection and Retention
- Entry Storage Systems
- Legacy
- Midrange and Enterprise Storage
- Storage Networking
- HPE Nimble Storage
Discussions
Discussions
Discussions
Forums
Discussions
Discussion Boards
Discussion Boards
Discussion Boards
Discussion Boards
- BladeSystem Infrastructure and Application Solutions
- Appliance Servers
- Alpha Servers
- BackOffice Products
- Internet Products
- HPE 9000 and HPE e3000 Servers
- Networking
- Netservers
- Secure OS Software for Linux
- Server Management (Insight Manager 7)
- Windows Server 2003
- Operating System - Tru64 Unix
- ProLiant Deployment and Provisioning
- Linux-Based Community / Regional
- Microsoft System Center Integration
Discussion Boards
Discussion Boards
Discussion Boards
Discussion Boards
Discussion Boards
Discussion Boards
Discussion Boards
Discussion Boards
Discussion Boards
Discussion Boards
Discussion Boards
Discussion Boards
Discussion Boards
Discussion Boards
Discussion Boards
Discussion Boards
Discussion Boards
Discussion Boards
Discussion Boards
Community
Resources
Forums
Blogs
- Subscribe to RSS Feed
- Mark Topic as New
- Mark Topic as Read
- Float this Topic for Current User
- Bookmark
- Subscribe
- Printer Friendly Page
- Mark as New
- Bookmark
- Subscribe
- Mute
- Subscribe to RSS Feed
- Permalink
- Report Inappropriate Content
08-17-2018 01:57 AM
08-17-2018 01:57 AM
HP VC FlexFabric-20/40 F8 connect with Cisco Nexus 5048UP not linked issue
Hi
we have two HP VC FlexFabric-20/40 F8 in our C7000 chassis slot 1/2 and as ethernet switch a Cisco Nexus 5048UP (1G and 10G only). I'm trying to bring up Q1.1 (we have a JG325B MPO Module in Q1 with a HP K2Q46A cable, this is a breakout cable which gets 4x10G SR from 40G SR). On the nexus side I've inserted a 10Gbase-SR Module and the port is up on the Nexus - but the FlexFabric module shows as port status "Not Linked". Is this configuration supported or do we have to switch to the X1-X8 ports with different cables & optics?
I've changed as well the "Connection Mode" but without luck.
We only have the HP virtual connect manager, no OneView.
Cheers & thanks
- Mark as New
- Bookmark
- Subscribe
- Mute
- Subscribe to RSS Feed
- Permalink
- Report Inappropriate Content
09-03-2018 01:23 AM
09-03-2018 01:23 AM
Re: HP VC FlexFabric-20/40 F8 connect with Cisco Nexus 5048UP not linked issue
Hi,
Do refer to HPE Virtual Connect for c-Class BladeSystem Setup and Installation Guide Version 4.62
HPE Virtual Connect FlexFabric-20/40 F8 Module requirements, Page#23
You may also refer to HPE Virtual Connect for c-Class BladeSystem User Guide Version 4.62
See if this helps you FCoE Cookbook for HP Virtual Connect.
Thank You!
I am an HPE Employee
Was the post useful? Click on the white KUDOS! Thumb below. Kudos is a way of saying thank you to a post.
Useful Links for ProLiant Servers
I work for HPE.
[Any personal opinions expressed are mine, and not official statements on behalf of Hewlett Packard Enterprise]