HPE Community read-only access December 15, 2018
This is a maintenance upgrade. You will be able to read articles and posts, but not post or reply.
Hours:
Dec 15, 4:00 am to 10:00 am UTC
Dec 14, 10:00 pm CST to Dec 15, 4:00 am CST
Dec 14, 8:00 pm PST to Dec 15, 2:00 am PST
BladeSystem Virtual Connect
cancel
Showing results for 
Search instead for 
Did you mean: 

HP VC for ESXi Configuration

 
azepeda
Occasional Contributor

HP VC for ESXi Configuration

So we have 4 interconnect bays, none linked. We have a C7000 Chassis with 16 blades with  ESXi installed. Our standalone ESXi hosts are configured with 6 NICS, 2 for management, 2 for vMotion and 2 set up as trunks to a Distributed vSwitch in vCenter and 2 Fibre connections for SAN. How can we get this same type of configuration set up using the Virtual Connect. X1 and X2 on the InterConnect bays are going to a Brocade Switch for SAN, X5 and X6 are Trunking to a Cisco switch, and all are going to different switches for Redundancy. All 4 InterConnects are set up the same way. How would be the best way to configure the Shared Uplink Sets and Server profiles to get our same type of set up as standalone hosts?