HPE Community
BladeSystem - General
1752579 Members
3026 Online
108788 Solutions
New Discussion

HP VCM unable to modify VCM after VCEM VC Domain Group placed into Maintenance Mode

 
tvliew
Occasional Contributor

‎01-15-2017 07:18 PM

‎01-15-2017 07:18 PM

HP VCM unable to modify VCM after VCEM VC Domain Group placed into Maintenance Mode

Hi HPE Community,

I have a HP Matrix Operating Environment with 1 x HP Blade Chassis. I am running on the below versions:

1. Virtual Connect using HP VC Flex-10 Enet Module on version 3.70

2. Virtual Connect Enterprise Manager on version 7.1.1

Normally if I HTTPS into the VCM (HP VC Flex-10 Enet Module), it would always say that "VC Domain locked by Virtual Connect Enterprise Manager". 

So under VCEM, under the VC Domain Group, I placed them into Maintenance Mode. Once I have placed them into Maintenance mode, I re-log into the VCM. It says that "VC Domain under maintenance by Virtual Connect Enterprise Manager". I could no longer view and modify the VCM.

Does anyone have any clues??

0 Kudos
Reply
The opinions expressed above are the personal opinions of the authors, not of Hewlett Packard Enterprise. By using this site, you accept the Terms of Use and Rules of Participation.