- Community Home
- >
- Servers and Operating Systems
- >
- HPE BladeSystem
- >
- BladeSystem - General
- >
- HP Virtual connect login issues
Categories
Company
Local Language
Forums
Discussions
Forums
- Data Protection and Retention
- Entry Storage Systems
- Legacy
- Midrange and Enterprise Storage
- Storage Networking
- HPE Nimble Storage
Discussions
Discussions
Discussions
Forums
Discussions
Discussion Boards
Discussion Boards
Discussion Boards
Discussion Boards
- BladeSystem Infrastructure and Application Solutions
- Appliance Servers
- Alpha Servers
- BackOffice Products
- Internet Products
- HPE 9000 and HPE e3000 Servers
- Networking
- Netservers
- Secure OS Software for Linux
- Server Management (Insight Manager 7)
- Windows Server 2003
- Operating System - Tru64 Unix
- ProLiant Deployment and Provisioning
- Linux-Based Community / Regional
- Microsoft System Center Integration
Discussion Boards
Discussion Boards
Discussion Boards
Discussion Boards
Discussion Boards
Discussion Boards
Discussion Boards
Discussion Boards
Discussion Boards
Discussion Boards
Discussion Boards
Discussion Boards
Discussion Boards
Discussion Boards
Discussion Boards
Discussion Boards
Discussion Boards
Discussion Boards
Discussion Boards
Community
Resources
Forums
Blogs
- Subscribe to RSS Feed
- Mark Topic as New
- Mark Topic as Read
- Float this Topic for Current User
- Bookmark
- Subscribe
- Printer Friendly Page
- Mark as New
- Bookmark
- Subscribe
- Mute
- Subscribe to RSS Feed
- Permalink
- Report Inappropriate Content
11-21-2014 08:55 AM - edited 11-21-2014 10:43 AM
11-21-2014 08:55 AM - edited 11-21-2014 10:43 AM
HP Virtual connect login issues
Hi Guys,
I have a HP Virtual connect 10/10D module connected to C7000 enclosure.
It is connected to each of the 2 servers present in the enclosure as follows:
eth0 -- X1 (Bay1, Bay2) -- OAM switch ----------> Operation and Maintenance Network
eth1 -- X2 (Bay1, Bay2) -- Traffic SW1 ----------> Traffic Network-1
eth2 -- X3 (Bay1, Bay2) -- Signalling SW1 ----------> Signalling Network -1
eth3 -- X4 (Bay1, Bay2) -- Signalling SW2 ----------> Signalling Network -2
eth4 -- X5 (Bay1, Bay2) -- Traffic SW2 ----------> Traffoc Network-2
So I have two problems here:
1. Whenever I try to login to Stanby VC flex module, it always takes me to Active VC flex module (kind of a redirection)
2. I am doing a redundancy test on VC flex modules :
Case 1:
I pull out all cables from active VC flex (say vc flex 1) . I can see that traffic is being handled by passive VC flex (VCflex2)without any problem -- SUCCESS
Case 2:
In the same VC flex module (with cable disconnected) , I am switching off the VC module (using the enclosure interconnect virtual option). Now, I can see that my traffic stops being handled by the virtual connect module.
I raised a case with HP and they asked me to check Active -- Active scenario. The same thing holds for the Active -- Active scenario as well. Whenever I switch one HP VCflex off, the whole traffic stops being processed by the module.
Thanks in advance..