HPE Community
BladeSystem - General
1753797 Members
7438 Online
108805 Solutions
New Discussion

Re: Have to E-Fuse Servers after VC Upgrade

 
Ihaqueit
Trusted Contributor

‎10-12-2021 09:39 AM - edited ‎10-12-2021 09:48 AM

‎10-12-2021 09:39 AM - edited ‎10-12-2021 09:48 AM

Re: Have to E-Fuse Servers after VC Upgrade

Reboot the vcflex via OA.

Power off no 2 first, then no 1 act as Active

Power off no 6 first, then no 5 act as Active.

Be careful it is redundant setup.

Checkout this,

https://community.hpe.com/hpeb/attachments/hpeb/bladescategory04/3150/1/VC%20Firmware%20Upgrade%20Steps%20and%20Procedures.pdf

I Haq
0 Kudos
Reply
The opinions expressed above are the personal opinions of the authors, not of Hewlett Packard Enterprise. By using this site, you accept the Terms of Use and Rules of Participation.