HPE Community read-only access December 15, 2018
This is a maintenance upgrade. You will be able to read articles and posts, but not post or reply.
Hours:
Dec 15, 4:00 am to 10:00 am UTC
Dec 14, 10:00 pm CST to Dec 15, 4:00 am CST
Dec 14, 8:00 pm PST to Dec 15, 2:00 am PST
BladeSystem Virtual Connect
cancel
Showing results for 
Search instead for 
Did you mean: 

Integrity blades and Virtual Connect

 
J. Martens
Occasional Visitor

Integrity blades and Virtual Connect

Anybody has configured Virtual Connect for Integrity Blades (BL860c/BL870c) and VLANs in an active/standby configuration using two 1/10Gb VC-Enet modules? A lot of possible configurations are descibed in the VC Ethernet cookbook but with one to use for Integrity blades? Thansk in advace. JackM
1 REPLY
vcblades
Frequent Advisor

Integrity blades and Virtual Connect

I haven't yet but it should not be no different than a full height blade - Also, you can easily configure VLANs in active/standby config using 2 1/10GB VC-Enet modules. Check with your network admin on which scenario is required from the cookbook - Scenario's 3~8 for your case.