HPE Community read-only access December 15, 2018
This is a maintenance upgrade. You will be able to read articles and posts, but not post or reply.
Hours:
Dec 15, 4:00 am to 10:00 am UTC
Dec 14, 10:00 pm CST to Dec 15, 4:00 am CST
Dec 14, 8:00 pm PST to Dec 15, 2:00 am PST
BladeSystem Virtual Connect
cancel
Showing results for 
Search instead for 
Did you mean: 

Link state without SmartLink on Active-Passive

 
ricdanger21
Advisor

Link state without SmartLink on Active-Passive

Hi there,

 

This is for situations where the driver does not support DCC (ex,: Linux):

 

- If I have an active-passive setup (VC1 active, VC2 passive) and don't enable smartlink, will the FlexNics go down when both uplinks are down?

- Also, if I use the crossconnect for some VNETs, will the FlexNics go down when both uplinks go down (without support for DCC in the driver)?

 

Regards.