BladeSystem Virtual Connect
cancel
Showing results for 
Search instead for 
Did you mean: 

Mix of BL460G6 and BL460G7 with FlexFabric

 
chuckk281
Trusted Contributor

Mix of BL460G6 and BL460G7 with FlexFabric

Ramu had a question regarding mixing of blades:

 

*******************

 

A requirement calls for installing BL460cG6 and BL460cG7 in a same enclosure with VC FlexFabric modules. Can we create FCoE connections and Ethernet connections for BL460cG7 servers & Ethernet connections for BL460cG6 servers.

 

I feel logically it should work, any inputs?

 

*******************

 

Dave replied:

 

*********************

 

                When using FCoE or iSCSI on G7 and FlexFabric, the FCoE or iSCSI will always be configured on the ‘b’ ports(1b – 2b). They will need to be configured in the FCoE or iSCSI sections below the Ethernet ports in the profile. This will leave 6 available ports to configure for Ethernet(1a, 2a, 1c, 2c, 1d & 2d).

 

                The ‘b’ ports will not show up or will not be available as Ethernet ports in the profile. The G6 servers will only have the 6 Ethernet ports and will not use the ‘b’ ports as it is not a CNA LOM.

 

*************************

 

is this clear for you? Any other questions or comments?