- Community Home
- >
- Servers and Operating Systems
- >
- BladeSystem
- >
- BladeSystem Virtual Connect
- >
- Re: Networking for HPE C7000 and Cisco Nexus switc...
-
- Forums
-
- Advancing Life & Work
- Advantage EX
- Alliances
- Around the Storage Block
- HPE Ezmeral: Uncut
- OEM Solutions
- Servers & Systems: The Right Compute
- Tech Insights
- The Cloud Experience Everywhere
- HPE Blog, Austria, Germany & Switzerland
- Blog HPE, France
- HPE Blog, Italy
- HPE Blog, Japan
- HPE Blog, Middle East
- HPE Blog, Russia
- HPE Blog, Saudi Arabia
- HPE Blog, South Africa
- HPE Blog, UK & Ireland
-
Blogs
- Advancing Life & Work
- Advantage EX
- Alliances
- Around the Storage Block
- HPE Blog, Latin America
- HPE Blog, Middle East
- HPE Blog, Saudi Arabia
- HPE Blog, South Africa
- HPE Blog, UK & Ireland
- HPE Ezmeral: Uncut
- OEM Solutions
- Servers & Systems: The Right Compute
- Tech Insights
- The Cloud Experience Everywhere
-
Information
- Community
- Welcome
- Getting Started
- FAQ
- Ranking Overview
- Rules of Participation
- Tips and Tricks
- Resources
- Announcements
- Email us
- Feedback
- Information Libraries
- Integrated Systems
- Networking
- Servers
- Storage
- Other HPE Sites
- Support Center
- Aruba Airheads Community
- Enterprise.nxt
- HPE Dev Community
- Cloud28+ Community
- Marketplace
-
Forums
-
Blogs
-
Information
-
English
- Subscribe to RSS Feed
- Mark Topic as New
- Mark Topic as Read
- Float this Topic for Current User
- Bookmark
- Subscribe
- Printer Friendly Page
- Mark as New
- Bookmark
- Subscribe
- Mute
- Subscribe to RSS Feed
- Permalink
- Email to a Friend
- Report Inappropriate Content
09-30-2018 02:31 AM - edited 09-30-2018 02:47 AM
09-30-2018 02:31 AM - edited 09-30-2018 02:47 AM
Networking for HPE C7000 and Cisco Nexus switches
Good morning everyone!
I'm looking at getting a new C7000 chassis with dual 10GB VC modules connected up to a pair of Cisco Nexus 9000 series switches.
Right now, I've got one port from each VC module connected to each of the Nexus switches, with a VPC peer link across the switches, as below:
However, there are a couple of things I'm unclear of:
- Should I change the two individual links from each VC module to a LACP/VPC link across the two Nexus switches?
- I notice the ports on the VC are broken down into two pairs and a group of four. Does it make any difference which ports I use on the VC modules, for LACP or otherwise?
Thanks in advance for any help with this.
- Mark as New
- Bookmark
- Subscribe
- Mute
- Subscribe to RSS Feed
- Permalink
- Email to a Friend
- Report Inappropriate Content
10-01-2018 03:49 AM
10-01-2018 03:49 AM
Re: Networking for HPE C7000 and Cisco Nexus switches
Hello,
You may refer to the HPE Virtual Connect Version 4.63 User Guide for more information.
You may also refer to the HPE Virtua Connect documentation at:
http://www.hpe.com/info/vc/manuals
Regards,
Vijayasarathy
Views expressed herein are my personal opinion and is not the views of HPE
Hewlett Packard Enterprise International
- Communities
- HPE Blogs and Forum
© Copyright 2021 Hewlett Packard Enterprise Development LP