- Community Home
- >
- Servers and Operating Systems
- >
- HPE BladeSystem
- >
- BladeSystem - General
- >
- Password recovery procedure for a 8-VC domain
Categories
Company
Local Language
Forums
Discussions
Forums
- Data Protection and Retention
- Entry Storage Systems
- Legacy
- Midrange and Enterprise Storage
- Storage Networking
- HPE Nimble Storage
Discussions
Discussions
Discussions
Forums
Discussions
Discussion Boards
Discussion Boards
Discussion Boards
Discussion Boards
- BladeSystem Infrastructure and Application Solutions
- Appliance Servers
- Alpha Servers
- BackOffice Products
- Internet Products
- HPE 9000 and HPE e3000 Servers
- Networking
- Netservers
- Secure OS Software for Linux
- Server Management (Insight Manager 7)
- Windows Server 2003
- Operating System - Tru64 Unix
- ProLiant Deployment and Provisioning
- Linux-Based Community / Regional
- Microsoft System Center Integration
Discussion Boards
Discussion Boards
Discussion Boards
Discussion Boards
Discussion Boards
Discussion Boards
Discussion Boards
Discussion Boards
Discussion Boards
Discussion Boards
Discussion Boards
Discussion Boards
Discussion Boards
Discussion Boards
Discussion Boards
Discussion Boards
Discussion Boards
Discussion Boards
Discussion Boards
Community
Resources
Forums
Blogs
- Subscribe to RSS Feed
- Mark Topic as New
- Mark Topic as Read
- Float this Topic for Current User
- Bookmark
- Subscribe
- Printer Friendly Page
- Mark as New
- Bookmark
- Subscribe
- Mute
- Subscribe to RSS Feed
- Permalink
- Report Inappropriate Content
07-23-2014 01:34 PM
07-23-2014 01:34 PM
Password recovery procedure for a 8-VC domain
Hello:
I have a C7000 chassis with 8 HP 1/10Gb VC-Enet Module modules connected together. This is an inhereted system and the password has been lost. I tried the documented reset procedure but it was not effective. I tried the procedure as documented unseating modules 1 and 2 which failed, and I also tried unseating all VC modules and powering on only VC 1 which was also ineffective. Even with dip switch 1 set the module rejected the password. I am unable to verify the location of the VC manager as I cannot log into the VC manager, the VC IP settings are incorrect.
Please advise how to reset these modules. I do not care about the configuration data. Thanks.
- Tags:
- Password reset
- Mark as New
- Bookmark
- Subscribe
- Mute
- Subscribe to RSS Feed
- Permalink
- Report Inappropriate Content
09-27-2014 03:21 PM
09-27-2014 03:21 PM
Re: Password recovery procedure for a 8-VC domain
You can try mixing up the order of the VC modules in the chassis and then using the OA option under Factory Reset for "Clear VC Mode" and see if you can then configure a new VC domain.