HPE Community read-only access December 15, 2018
This is a maintenance upgrade. You will be able to read articles and posts, but not post or reply.
Hours:
Dec 15, 4:00 am to 10:00 am UTC
Dec 14, 10:00 pm CST to Dec 15, 4:00 am CST
Dec 14, 8:00 pm PST to Dec 15, 2:00 am PST
BladeSystem Virtual Connect
cancel
Showing results for 
Search instead for 
Did you mean: 

Question on Flexfabric module support in Bay 3/4 only

 
chuckk281
Trusted Contributor

Question on Flexfabric module support in Bay 3/4 only

Steve had a Virtual Connect interconnect bay location question:

 

************

 

I have a Integrity customer that only wants to use the CNA/s Mezz Cards and two FlexFabric  modules in Bay 3 and 4 only. The HP Product Bulletin Quick Spec shows this as a valid configuration but I want to check with the Blade community to ensure that this will be in fact supported.

 

****************

 

Mark replied:

 

*****************

 

It is supported as it was determined that customers might have environments where 10Gb is necessary with older servers that only had 1Gb LOMs. They didn't want to use the 1Gb LOMs but wanted Virtual Connect. That prompted us to release 3.x firmware where VCM would run in bays other than 1 or 2.

 

**************

 

Are you using this type of configuration? Let us know how it works for you.