HPE Community read-only access December 15, 2018
This is a maintenance upgrade. You will be able to read articles and posts, but not post or reply.
Hours:
Dec 15, 4:00 am to 10:00 am UTC
Dec 14, 10:00 pm CST to Dec 15, 4:00 am CST
Dec 14, 8:00 pm PST to Dec 15, 2:00 am PST
BladeSystem Virtual Connect
cancel
Showing results for 
Search instead for 
Did you mean: 

Reconfigure VLAN LACP Timer on Cisco switch when used in ESX host environment

 
chuckk281
Trusted Contributor

Reconfigure VLAN LACP Timer on Cisco switch when used in ESX host environment

John was looking for some LACP timing help:

 

**********************

 

Experts,

 

A customer is receiving these messages :
 
    [102] lacp_timer_msg_handler(246): Mismatched timer id. Ignoring timeout event for rid type IF-Rid: ifidx 0x1a003000: ch_num 0

 

I seem to remember an email describing this and the solution was to go into the Cisco switches and to change the “lacp_timer” value. Anyone remember what that value should be?

 

*********************

 

Armand had the info:

 

******************

 

Hi John,

 

The NX-OS version should be : 4.2(1)N2(1) , at least.

The value should be set from :

LACP_Timeout=Long  Timeout (30s)   

to

LACP_Timeout=Short Timeout (1s)

 

By executing :

 

switch(config-if)# lacp rate fast

 

***********************

 

Any other comments or suggestions for John?