HPE Community read-only access December 15, 2018
This is a maintenance upgrade. You will be able to read articles and posts, but not post or reply.
Hours:
Dec 15, 4:00 am to 10:00 am UTC
Dec 14, 10:00 pm CST to Dec 15, 4:00 am CST
Dec 14, 8:00 pm PST to Dec 15, 2:00 am PST
BladeSystem Virtual Connect
cancel
Showing results for 
Search instead for 
Did you mean: 

SNMP Trap for Virtual Connect

 
chuckk281
Trusted Contributor

SNMP Trap for Virtual Connect

Chairutthana needed some SNMP info:

 

*********************

 

Dear All,

 

Our TS/CMS team in Thailand, try to integrate the SNMP trap from VC-Flex10 to NNM/HPOV server for monitor alarm.

Currently alarm can be sent/received between VC-Flex10 and NNM/HPOV, but we need more information about the traps. (refer to attachment file)

 

Can anyone help describe or point to the document which described on these traps from VC?

 

Here is example messages which extract from the file.

 

….

vcCheckpointCompleted

vcCheckpointTimeout

vcDomainManagedStatusChange

vcDomainStackingLinkRendundancyStatusChange

vcEnclosureManagedStatusChange

vcEnetNetworkManagedStatusChange

vcFcFabricManagedStatusChange

vcModPortInputErrorsDown

vcModPortInputErrorsUp

vcModPortInputUtilizationDown

vcModPortInputUtilizationUp

vcModPortOutputErrorsDown

vcModPortOutputErrorsUp

vcModPortOutputUtilizationDown

vcModPortOutputUtilizationUp

vcModuleDomainRoleChange

vcModuleManagedStatusChange

vcPhysicalServerManagedStatusChange

vcProfileManagedStatusChange

vcTestTrap

 

In additional, there is a question from customer, does the VC-Flex10 has capability to set threshold/monitor internal processor/memory (like network switch).

And is there any possibility to monitor or generated alarm when VC module is fail-over.

 

Thank you very much!

 

*********************

 

Madhu had some additional info:

 

*********************

 

MIB files for Virtual Connect. http://h20000.www2.hp.com/bizsupport/TechSupport/SoftwareDescription.jsp?swItem=MTX-781487480f2f4d6ea5ac2d2050&taskId=135&swLang=8&lang=en&cc=us&mode=5&

File names, are these the only ones relevant to VC flex10?:

vc-domain-mib
vc-module-mib

 

 

Where can I get more information about these traps below to figure out if they are relevant or not and what the severity levels mean?

 

vcDomainManagedStatusChange

The summary managed status of the domain has changed.

vcCheckpointTimeout

The checkpoint valid status remained false for more than
         five minutes.

vcCheckpointCompleted

A checkpoint operation has completed following a checkpoint timeout
         trap. The checkpoint valid status is true again. This trap is
         not sent on every checkpoint completion, but only on a checkpoint
         completion after a vcCheckpointTimeout trap has been sent.

 

 

*****************

 

Any more help for these guys?