HPE Community read-only access December 15, 2018
This is a maintenance upgrade. You will be able to read articles and posts, but not post or reply.
Dec 15, 4:00 am to 10:00 am UTC
Dec 14, 10:00 pm CST to Dec 15, 4:00 am CST
Dec 14, 8:00 pm PST to Dec 15, 2:00 am PST
BladeSystem Virtual Connect
Showing results for 
Search instead for 
Did you mean: 

Turning off Throughput Stats while in Production...

Go to solution
Valued Contributor

Turning off Throughput Stats while in Production...

I have deployed VC Flex10 modules in production with no problems so far. I installed a new set in an enclosure

 and was monitoring for operation. I noticed that both modules' Cache useage was almost doubled what the other ones were.


After checking ALL settings on each VC set, the only difference was the setting enabling throughput stats,( under Configuration>Ethernet>Advanced>Other......check box at bottom of page to enable ).


I think this could be unchecked and applied without interupting production traffic?


My OA is 3.30 and VC is 3.70.





Michael Leu
Honored Contributor

Re: Turning off Throughput Stats while in Production...

I've enabled and disabled this option without any impact on a production enclosure. Seems to work fine...


OA 3.70 and VC 3.70