HPE Community read-only access December 15, 2018
This is a maintenance upgrade. You will be able to read articles and posts, but not post or reply.
Hours:
Dec 15, 4:00 am to 10:00 am UTC
Dec 14, 10:00 pm CST to Dec 15, 4:00 am CST
Dec 14, 8:00 pm PST to Dec 15, 2:00 am PST
cancel
Showing results for 
Search instead for 
Did you mean: 

VC-ENET status

 
Sameer_Nirmal
Honored Contributor

VC-ENET status

Hi All, Does anyone know what would cause these errors and any fix? We lost the blades connectivity and it was re-gained after a while. OA : 2.20 VC-ENET : 2.21 OA: Health status of interconnect in bay 6 changed to Unknown OA: Health status of interconnect in bay 2 changed to Unknown OA: Health status of interconnect in bay 5 changed to Unknown OA: Health status of interconnect in bay 2 changed to OK OA: Health status of interconnect in bay 2 changed to Unknown OA: Health status of interconnect in bay 6 changed to OK OA: Health status of interconnect in bay 6 changed to Unknown OA: Health status of interconnect in bay 5 changed to OK OA: Health status of interconnect in bay 5 changed to Unknown Thanks in advance. [Updated on 9/22/2009 8:49 PM]
1 REPLY
johnschaves
Occasional Visitor

VC-ENET status

check the mezz screws on the back side of the cabinet, make sure they are tightened down. The mexzz blade gets loose over time from installing and removing blades and can cause this type of error, and all red x's in sim.