- Community Home
- >
- Servers and Operating Systems
- >
- HPE BladeSystem
- >
- BladeSystem - General
- >
- VC Flex-10 module LACP to Alcatel 7700 - LACP nego...
BladeSystem - General
1748138
Members
3773
Online
108758
Solutions
Forums
Categories
Company
Local Language
back
Forums
Discussions
Forums
- Data Protection and Retention
- Entry Storage Systems
- Legacy
- Midrange and Enterprise Storage
- Storage Networking
- HPE Nimble Storage
Discussions
Discussions
Discussions
Forums
Discussions
back
Discussion Boards
Discussion Boards
Discussion Boards
Discussion Boards
- BladeSystem Infrastructure and Application Solutions
- Appliance Servers
- Alpha Servers
- BackOffice Products
- Internet Products
- HPE 9000 and HPE e3000 Servers
- Networking
- Netservers
- Secure OS Software for Linux
- Server Management (Insight Manager 7)
- Windows Server 2003
- Operating System - Tru64 Unix
- ProLiant Deployment and Provisioning
- Linux-Based Community / Regional
- Microsoft System Center Integration
Discussion Boards
Discussion Boards
Discussion Boards
Discussion Boards
Discussion Boards
Discussion Boards
Discussion Boards
Discussion Boards
Discussion Boards
Discussion Boards
Discussion Boards
Discussion Boards
Discussion Boards
Discussion Boards
Discussion Boards
Discussion Boards
Discussion Boards
Discussion Boards
Discussion Boards
Blogs
Information
Community
Resources
Community Language
Language
Forums
Blogs
Topic Options
- Subscribe to RSS Feed
- Mark Topic as New
- Mark Topic as Read
- Float this Topic for Current User
- Bookmark
- Subscribe
- Printer Friendly Page
- Mark as New
- Bookmark
- Subscribe
- Mute
- Subscribe to RSS Feed
- Permalink
- Report Inappropriate Content
10-01-2009 09:43 AM
10-01-2009 09:43 AM
VC Flex-10 module LACP to Alcatel 7700 - LACP negotiates but packets not flowing!
Hi everyone Looking for advise on those who have setup a 2-link (or more) LACP to 2 ports on an Alcatel 7700 switch. My network admin has configured them for dynamic LACP on the switch end, he reports that it's negotiated and one of them is a "primary port". On the VC end, the network shows both links as having Active and Active status. Didn't find anything special to configure to make it use LACP. However my blade whose NIC is assigned to the network using that uplink, can't communicate with the outside world. Tearing down the LACP and doing a simple 1-1 uplink works. Does VC have a more comprehensive interface where I can do troubleshooting, like command line/ping/show mac addresses flowing through the uplink etc? Appreciate any responses!
The opinions expressed above are the personal opinions of the authors, not of Hewlett Packard Enterprise. By using this site, you accept the Terms of Use and Rules of Participation.
News and Events
Support
© Copyright 2024 Hewlett Packard Enterprise Development LP