BladeSystem Virtual Connect
cancel
Showing results for 
Search instead for 
Did you mean: 

VC Flex-10 module LACP to Alcatel 7700 - LACP negotiates but packets not flowing!

 
Jeffrey
Occasional Visitor

VC Flex-10 module LACP to Alcatel 7700 - LACP negotiates but packets not flowing!

Hi everyone Looking for advise on those who have setup a 2-link (or more) LACP to 2 ports on an Alcatel 7700 switch. My network admin has configured them for dynamic LACP on the switch end, he reports that it's negotiated and one of them is a "primary port". On the VC end, the network shows both links as having Active and Active status. Didn't find anything special to configure to make it use LACP. However my blade whose NIC is assigned to the network using that uplink, can't communicate with the outside world. Tearing down the LACP and doing a simple 1-1 uplink works. Does VC have a more comprehensive interface where I can do troubleshooting, like command line/ping/show mac addresses flowing through the uplink etc? Appreciate any responses!