HPE Community read-only access December 15, 2018
This is a maintenance upgrade. You will be able to read articles and posts, but not post or reply.
Hours:
Dec 15, 4:00 am to 10:00 am UTC
Dec 14, 10:00 pm CST to Dec 15, 4:00 am CST
Dec 14, 8:00 pm PST to Dec 15, 2:00 am PST
BladeSystem Virtual Connect
cancel
Showing results for 
Search instead for 
Did you mean: 

VC Switch | Commands and Output

 
grinningdevil
Valued Contributor

VC Switch | Commands and Output

Hello Guys ! 

Few direct questions if someone can please help me out - 

  • What is the CLI command to check that a VC switch is in Access gateway mode (NPIV)
  • What is the expected output of this command

 

  • If the switch is not in access gateway mode, what is the CLI command to configure it in access gateway mode (NPIV)
  • What is the expected output of this command.


Thanks !!!