HPE Community
BladeSystem - General
1753755 Members
4656 Online
108799 Solutions
New Discussion

VC with "Module not operational" status

 
topokin
Advisor

‎11-22-2011 11:26 AM - edited ‎11-23-2011 03:36 AM

‎11-22-2011 11:26 AM - edited ‎11-23-2011 03:36 AM

VC with "Module not operational" status

We just added a VC to our Blade Chasis and will like to update the firmware. However using vcsu indicated that the modules are not operational, thus there is no possibility to update the firmware.

 

The modules are running. How then can I bring them up in order to be able to update the firmware?

 

The problem is I cannot even setup the VC, I get the error message "Active Virtual Connection Manager not at this IP address" and the UserName / Password fields are not active to type-in anything.

 

Thanks

 

I have been able to resolved the problem by moving the VC to bay 1 / 2 and was able to update the firmware.

0 Kudos
Reply
The opinions expressed above are the personal opinions of the authors, not of Hewlett Packard Enterprise. By using this site, you accept the Terms of Use and Rules of Participation.